The Wii-Clip v1 for D2CKey is possibly the easiest way to install a high wire count chip like the D2CKey, or for that matter any chip. Now what would have been a 31-wire install has no wires at all, the only part you need to solder when using the Wii-Clip D2CKey are the solder pads on the chip to the Wii Clip ribbon cable itself. If you are a novice at soldering, even low wire chips like the Argon will still be out of your league, so using the Wii-Clip for a D2CKey install could be one of the best options for novice installers. No need for cutting wires to length, striping wires, or being frustrated with the super fine points located on the DVD controller IC, the Wii Clip v1 has made D2C installations for novices easier then ever before. If you’re looking at chipping your D2C console yourself or don’t have an installer locally, the WiiClip could be the best option for you. This is almost a fool proof solution that will virtually guarantee that you do not damage your Wii console.
We have seen many people damage their D2C drive boards beyond repair trying to install chips, and then having to pay over $160 to buy a new drive replacement to repair the damage that was done on top of now having to pay someone to do the installation for them. So these Wii Clip D2CKey are almost an insurance against damaging your Wii drive when trying to install a chip into the console without much prior experience with soldering or chip installations. Buy the latest wireless Wii-Clip for D2CKey here today!
| 
