The Xecuter CoolRunner CPU reset cleaner addon board is used to help clean up the signal on the CPU RST line going from the CoolRunner to the Xbox 360 mother board. Those familiar with doing RGH 1 & 2 installs know that some consoles you can significantly decrease boot times by running the CPU RST wire through various capacitor and resistor combinations. For example some consoles work great using a 670p cap with a 3.3k resistor and this combination reduces boot times. The Xecuter CPU reset cleaner addon boards come with 3 different selectable capacitor values being 470p, 560p & 680p and 3 different resistor values being 1k, 2, & 3.3k. These are easily selectable via a dip switch system on the PCB and trying different combinations is as simple as flicking a switch.
It is also possible with these addon boards to run more than one resistor and capacitor value at one time, for example one of the guy’s on the forms had a big block Jasper he was doing an RGH 2.0 on and was not booting under 5min and averaged around 7min. He ran one of these Xecuter CoolRunner CPU reset cleaner addon boards with the 470p & 680p capacitor values enabled and all three of the resistor values enabled and was able to get the boot times down to between 20sec and 50sec which was a huge improvement. Experimenting with different capacitor & resistors by themself can be time consuming soldering & de-soldering different combinations, the Xecuter CoolRunner CPU reset cleaner addon boards make trying different combinations a quick and painless process which will speed up install times and save lots of frustration when trying to achieve the best possible booting times.
While each 360 mother board type can be different and what works on one type of board might not work well on another, but there is already a support thread on the Xecuter forms for the CPU Reset cleaner where people are posting their results and settings used on these boards and we urge you to pop over and have a read. These will be a big help to those wanting to do RGH 2.0 as we will know this is a bit pain in the butt trying to get boot times acceptable using the RGH 2.0 method, so for such a low price and ease of use these boards can be a time saving device and will help you achieve the best possible boot times with minimal fuss. Buy the Xecuter CoolRunner CPU reset cleaner addon boards here today.