These are the Xecuter Xenon JTAG Kit #8 to be used in conjunction with the Nand-X on all 360 Xenon boards, for those of you not doing the wire and diode trick one of these sets needs to be left in the console once you have done flashing so the console will boot, without leaving in this kit the console wont boot after flashing has been done, also this kit is slightly neater than doing the diode and wire trick and really don’t cost to much. One of these sets is included in the Nand-X package, but if you are planning on doing multiple consoles you will need to buy extra sets to leave in the consoles after you have done the JTAG process, so this is where the Xecuter Xenon JTAG kit #8 comes in. Similar to the #2 kit this one solders to the top of the motherboard, the only difference is that you will need to solder in two modules for the Xenon boards instead of one for the other board types.
| 
